Instructions should to you follow.
Installation method
1. First will fill the brake oil pump under lie flat, do not have air, silk mouth is verybig, can be seen there was a bubble.
2. See above screw, tubing with good twist screws, do not tighten, request screwside holes can be exposed.
3. This is the key, be sure to look good. Link on the pump and tubing, and highup, the oil pump oil cup, and then pressure several times at random (10) handle,OK now just waiting for (don't allow any action) 5-10 minutes later, in the aboveside didn't tighten the screw hole will see the brake oil flow out, then lock screw,exhaust.
4. Hydraulic clutch exhaust complete inspection methods: push the pump underthe wire to the pump body en croute, hand pinch on the pump handle, handle tip to move about 3 cm, knead not bottom go to, is correct. (press the handle until the pressure not bottom go to, there are about 3 cm distance handlebar, it finished the exhaust, but loading debugging), loading, must pull wire all out, again under the fixed pump, (make sure to loosen the clutch handle, wire all stretchedout)
==================
Good thing I've bled out hydraulic systems before. I can actually make a bit of sense out of this.
= new reply since forum marked as read
