Welcome to DU! The truly grassroots left-of-center political community where regular people, not algorithms, drive the discussions and set the standards. Join the community: Create a free account Support DU (and get rid of ads!): Become a Star Member Latest Breaking News General Discussion The DU Lounge All Forums Issue Forums Culture Forums Alliance Forums Region Forums Support Forums Help & Search
13 replies = new reply since forum marked as read
Highlight: NoneDon't highlight anything 5 newestHighlight 5 most recent replies
How long does a can of (Original Post) Texasgal Jan 2012 OP
This message was self-deleted by its author Tesha Jan 2012 #1
Thanks Tesha! Texasgal Jan 2012 #2
This message was self-deleted by its author Tesha Jan 2012 #3
Thank you so much. Texasgal Jan 2012 #4
Not quite. Leave the skin on until you are ready to use the paint. TheMadMonk Jan 2012 #7
My dad would always stir it up with a drill Ruby the Liberal Jan 2012 #5
Latex doesn't like to be frozen pipoman Jan 2012 #6
I store my used paint cans upside down Major Nikon Jan 2012 #8
I can't wait to tell that idea to my wife Kolesar Jan 2012 #9
What does that do Ruby the Liberal Jan 2012 #10
Opened paint cans will eventually dry out Major Nikon Jan 2012 #11
Well now, isn't that something. Ruby the Liberal Jan 2012 #13
A vapor barrier, like a piece of very thin plastic sheeting or Saran Wrap Adsos Letter Jan 2012 #12

Response to Texasgal (Original post)

Texasgal

(17,045 posts)
2. Thanks Tesha!
Mon Jan 2, 2012, 10:44 PM
Jan 2012

The paint is a big commercial drum that is plastic. No rusted can.

Is there anything I should look for?

Response to Texasgal (Reply #2)

Texasgal

(17,045 posts)
4. Thank you so much.
Mon Jan 2, 2012, 11:41 PM
Jan 2012

I have some interior paint in a plastic tub in the garage. I want to use it to get some scuffs, old looks off my walls. It's about five years old.

Thank you for your answer!

 

TheMadMonk

(6,187 posts)
7. Not quite. Leave the skin on until you are ready to use the paint.
Wed Jan 4, 2012, 03:28 AM
Jan 2012

Use a broad brush to recover liquid from the underside.

Use a sharp knife tip to lift an edge of the skin and also to separate it from the walls of the container. Try to remove in one piece.

Ruby the Liberal

(26,219 posts)
5. My dad would always stir it up with a drill
Tue Jan 3, 2012, 02:53 AM
Jan 2012

and then filter it through used pantyhose into a clean container, then dump the unused back into the original and restore it.

 

pipoman

(16,038 posts)
6. Latex doesn't like to be frozen
Tue Jan 3, 2012, 07:47 PM
Jan 2012

it can cause it to separate and not adhere well. If it has frozen I would test it on a small area first.

Major Nikon

(36,827 posts)
11. Opened paint cans will eventually dry out
Thu Jan 5, 2012, 10:35 PM
Jan 2012

Storing them upside down will help to keep that seal from degrading as quickly. I suspect it will work on plastic as well, but some of those I've seen tend to seal better because you don't have to pry the lid off which distorts it.


http://www.remodeling-sanantonio.com/frequently-asked-questions/83/

Adsos Letter

(19,459 posts)
12. A vapor barrier, like a piece of very thin plastic sheeting or Saran Wrap
Fri Jan 6, 2012, 12:42 AM
Jan 2012

laid down on the paint surface also works very well for 5-gallon buckets.

Latest Discussions»Culture Forums»DIY & Home Improvement»How long does a can of