Any drafters out there? I've been looking for a chart that has complete

hedgehog

(1000+ posts) Send PM | Profile | Ignore

Thu Jul-28-11 11:15 AM
Original message

Any drafters out there? I've been looking for a chart that has complete

info on the cross section of steel channel. The charts I've seen are fine for engineering calculations, but I haven't seen any that give the angles and radii on the legs. I can work around this, but now I'm curious.

Printer Friendly | Permalink | | Top

Kolesar

(1000+ posts) Send PM | Profile | Ignore

Thu Jul-28-11 11:25 AM
Response to Original message

1. How about at the steel companies?

Nucor / Vulcraft
Mittal?

Printer Friendly | Permalink | | Top

hedgehog

(1000+ posts) Send PM | Profile | Ignore

Thu Jul-28-11 11:33 AM
Response to Reply #1

2. I'll check them out, but so far no luck. I've checked some engineering

blogs, and it seems that no one has this info. We've all gotten along without it, but now I'm on a quest!

Printer Friendly | Permalink | | Top

DU AdBot (1000+ posts)

Thu Apr 25th 2024, 04:49 PM
Response to Original message

Advertisements [?]

Top

Powered by DCForum+ Version 1.1 Copyright 1997-2002 DCScripts.com
Software has been extensively modified by the DU administrators

Important Notices: By participating on this discussion board, visitors agree to abide by the rules outlined on our Rules page. Messages posted on the Democratic Underground Discussion Forums are the opinions of the individuals who post them, and do not necessarily represent the opinions of Democratic Underground, LLC.