Hell Hath No Fury
(1000+ posts)
Send PM |
Profile |
Ignore
|
Thu Jan-15-09 04:33 PM
Original message |
Exterior sconce help needed BAD! |
|
I am installing three exterior sconces to a house that has clapboard-type siding -- the material is one of those cement products that does not warp/rot. My problem is slight vertical angle the siding creates when attaching the sconce -- if attached correclt, there is a large space along the top where the fixture sits away from the siding, if attached so the entire base plate sides flush against the siding, the sconce itself "tilts" slightly up ward.
Hwo do I do this? Do I cut the siding out and place the fixture base against the exterior wall, or put some sort of shim in the top of the ficture then caulk around it? What????
Thanks in advance!
Hell
|
amerikat
(1000+ posts)
Send PM |
Profile |
Ignore
|
Thu Jan-15-09 07:30 PM
Response to Original message |
1. You need a mounting block. |
Hell Hath No Fury
(1000+ posts)
Send PM |
Profile |
Ignore
|
Fri Jan-16-09 11:08 AM
Response to Reply #1 |
|
Edited on Fri Jan-16-09 11:08 AM by Hell Hath No Fury
Thank you so much -- I knew there had to be an easier way to do this! :loveya: :loveya: :loveya: :loveya: :loveya:
Hell
|
yy4me
(1000+ posts)
Send PM |
Profile |
Ignore
|
Thu Mar-19-09 11:41 AM
Response to Original message |
3. I bought mounting blocks at DH that are simple octagonal |
|
spacers probably 6" X 8" that are designed to do just the job you need. They were very inexpensive and paint-able. I forget now, but I think you can get them already primed or in natural color. Did the job perfectly.
You attach the plate to the house, then attach the light to the plate.
|
DU
AdBot (1000+ posts) |
Sun May 05th 2024, 10:38 PM
Response to Original message |